 |
Firmware for the High-Current Battery Balancer [1410221B.HEX]
The revised (v1.1) firmware for the Four Battery High-Current Battery Balancer.
This is an upgrade from the earlier 1410221A.HEX:
- Communication between two Balancers now works properly and they will act as a 5-8 cell/battery balancer (within the maximum 60V limit).
- The default cell low voltage threshold has been increased from 2.5V to 2.7V
- Serial commands must now be terminated with newline ('\n'), not carriage return ('\r').
|
 |
High Current Battery Balancer PCB [14102211]
The PCB for the High-Current Four-Battery Balancer.
Four-layer PCB with plated through holes, green solder mask and silkscreen overlay.
108 x 80mm.
|
 |
ATSAML10E16A-AUT programmed for the High-Current Battery Balancer [1410221B.HEX]
A 32-bit, 32-pin Atmel ATSAML10E16A-AUT ARM processor (SMD quad flat pack) programmed with the firmware for the High-Current Four Battery Balancer.
It is programmed with v1.1 of the firmware, which is an upgrade from the earlier 1410221A.HEX:
- Communication between two Balancers now works properly and they will act as a 5-8 cell/battery balancer (within the maximum 60V limit).
- The default cell low voltage threshold has been increased from 2.5V to 2.7V
- Serial commands must now be terminated with newline ('\n'), not carriage return ('\r').
|
 |
High Current Battery Balancer PCB pattern (PDF download) [14102211]
A PDF with the PCB design of the High-Current Four-Battery Balancer.
All four layers are in a single PDF.
Due to this being a four-layer board, etching it yourself is not practical or recommended. The pattern is provided as a reference only.
|
